Here is a tip for punching a disc from a small piece of metal from @wendyjonewmetaldesigns - “When I have a piece of metal that is too small to hang onto for cutting out a disc in my disc cutter, I adhere it to the sticky side of a Post It Note and position the metal while holding the paper. And (although not pictured) when I don’t have a Post It Note available, I set the edge of my metal piece next to the edge of a piece of paper and set a piece of tape down on top of the two and then hold the paper to position the metal. These methods allow even the smallest metal pieces to be cut this way.” I love this idea so much Wendy thanks for taking the time to share with us ❤️ #disccutter #jewelrymakingtools #jewelrymakersofinstagram